IDENTIFIKASI PENYEBAB DAN UPAYA PENGURANGAN FLOWOUT REJECT QUALITY CONTROL: STUDI KASUS

Monica Puspitadewi(1*),


(1) 
(*) Corresponding Author

Abstract


IMM department is the business core of PT. X, it was noticed that there were many reject products passed to the next department and to the customer. Internal Block Belt data is data flowout to internal customer in 2015 which showed that reject flowout was still higher than the target (3%). Therefore, the company wants to identify the cause of flowout reject and what improvements can be applied to reduce it. The root cause of flowout reject is found out using fishbone diagram and priorities determination is using FMEA. The root cause of reject flowout is because of too much workload to be completed by the QC inspector. Suggestions given are the changes of form Inspection Report and additions of 1 QC inspector.

 


Keywords


Flowout Reject identification, FMEA, fishbone

Full Text:

PDF

References


Besterfield, D. H. (1994). Quality Control. United States: Prentice-Hall, Inc.

Meyers, F. E., & Stewart, J. R. (2002). Motion and Time Study for Lean Manufacturing. New Jersey: Pearson Education, Inc.

Meyers, F. E., & Stewart, J. R. (2002). Motion and Time Study for Lean Manufacturing. New Jersey: Pearson Education, Inc.

Niebel, B. W. (1988). Motion and Time Study. United States: Richard D. Irwin, Inc.

Wignjosoebroto, S. (2006). Ergonomi Studi Gerak dan Waktu. Surabaya: Guna Widya.

Wignjosoebroto, S. (1986). Teknik Tata Cara & Pengukuran Waktu Kerja. Surabaya: Institut Teknologi Sepuluh Nopember.

Sutalaksana, I. Z. (2006). Teknik Perancangan Sistem Kerja. Bandung: ITB.


Refbacks

  • There are currently no refbacks.